-
Keep a calibration system pressurized with a fluid or gas while venting the pressure from the device being calibrated
-
Use to slowly or quickly bleed pressure from a line after a calibration is complete Easily connect between the end of a Quick-test hose and the process connection Keep fluid or contaminates out of the hand pump, calibrator or nitrogen control device
-
Install between a pressure gauge and the process and isolate the process from the gauge to perform a calibration of the gauge. After completing the calibration open the valve and place the gauge on-line, all without blowing down the system. * Use whenever there is a gauge that needs frequent calibration or verification
-
Use to mount gauges on Ralston Instruments model APGV, HPGV, XHGV hand pumps Swivels allow the user to easily switch gauges on a single hand pump Made in USA
-
Turn any Quick-test XT adapter into a permanent installation with the addition of a cap and chain Seals any male Quick-test XT adapter Install on any Quick-test XT adapter for permanent installation in the field Note that these are not compatible with QT or QS hoses. Please use only on Quick-test XT adapters Made in USA
-
Plug a hose to prevent fluid from leaking out Pressure-tight with just your fingers Made in USA
-
Connect 3 Quick-test XT 10,000 psi hoses together without a wrench or thread sealant Durable forged construction Full flow through all ports Note that these are not compatible with QT or QS hoses. Please use Quick-test XT hoses Made in USA
-
Excellent for safely connecting two Quick-test XT 10,000 psi hoses through an enclosure, truck, or panel wall Bulkhead seals so no liquid or moisture can get into a control panel or enclosure Use to connect a Quick-test XT hose on the inside of an enclosure to a Quick-test XT hose on the outside of the enclosure Will connect through a wall that is up to 0.5 in (1.3 cm) Note that these are not compatible with QT or QS hoses. Please use Quick-test XT hoses Made in USA
-
Excellent for safely connecting two Quick-test hoses through an enclosure, truck, or panel wall Bulkhead seals so no liquid or moisture can get into a control panel or enclosure Use to connect a Quick-test hose on the inside of an enclosure to a Quick-test hose on the outside of the enclosure Will connect through a wall that is up to 0.5 in (1.3 cm) thick Made in USA
-
Connect 2 Quick-test XT 10,000 psi hoses together quickly and easily Quick-test XT connection makes connecting two high pressure hoses together quick and easy Note that these are not compatible with QT or QS hoses. Please use Quick-test XT hoses Made in USA
-
Connect to SAE/MS ports on pressure calibrators, pipelines and other processes Connect using an o-ring seal avoids issues with vibration, heating and cooling Excellent for aerospace and automotive connections with female SAE/MS ports Made in USA
-
Connect a pressure gauge with Metric male parallel thread to a Quick-test hose A unique design allows connection to any male metric connections using a pressure-assisted o-ring seal Pressure helps to seal the fitting better Stainless steel construction Made in USA
-
Connect to Female Metric thread comparators, pressure pumps and devices under test Excellent for use in the laboratory for adapting Female Metric pressure comparators to Quick-test Use with any Quick-test Quick-connect adapter or hose Made in USA
-
Connect a Ralston Quick-test hose to a 1620 connection Adapt any Hydrotechnik Minimess or equivalent 16 x 2.0 connection to a Ralston Quick-test adapter Made in USA
